USB Driver Installation Instructions for Windows 98/ME
(For all Ross-Tech USB interfaces with VCDS version 805 or newer)

Notes:  These instructions are for Windows 98.   Installation under Windows ME should be similar, but not necessarily identical.

1. Plug your Ross-Tech USB Interface to your PC's USB port (It is not necessary to connect the interface to a car yet).   The Add New Hardware Wizard should appear:
   
           
   in this dialog, click [ Next > ].
    

2. The Add New Hardware Wizard should give you the following choices:
   
   
   
   in this dialog, select "Search for the best driver for your device" then click  [ Next > ].
    

3. The Add New Hardware Wizard should give you the following choices:
   
   
   
   in this dialog, ensure that only "Specify a location:" is checked, then click the [ Browse... ] button.
    

4. A Browse for Folder dialog should appear: 
   
    
   
   In this dialog, please browse to the location where you've installed VCDS, typically C:\Ross-Tech\VCDS.
   Once you've highlighted the location where you've installed VCDS, the [ OK ] button should become enabled. 
   Click the [ OK ] button.
   
    

5. You will then return to the Add New Hardware Wizard and the specified location will be filled in for you.
   
   
   
   Click the [ Next > ] button.
    

6. The following dialog should appear:
   
   
   
   Click the [ Next > ] button.
    

7. The following dialog should appear:
   
   
   
   Click the [ Finish ] button.
   
    

8. Start VCDS and go to the [ Options ] screen.   
   Select the USB Port. 
   Click the [ Test ] button.
   The results should look like this:
   
   
   

9. Go test it on a car.  :-)

Note: If you run into problems with this procedure, feel free to Contact us while you are in front of your PC, connected to your vehicle.

Copyright � 2008 by Ross-Tech LLC.  All rights reserved.